THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

I think this is the wish list to Santa! ))

Back in business!

Finally finished repairing the rear axle! :D I had to weld completely two old holes on both parts of the axle's tube, drill new holes for the locking bolt, and cut a new thread. During assembling at this time we used the analog of Loctite, hopefully in the nearest future i won't need any repair of t...

Not so sure about the color scheme but that is a pretty nice 710k Andre posted.. Is there more info on that one? That one is from here: http://pinzgauer.spb.ru/gallery/pinzgauer-photo/techcentr-gallery It is a kind of showcar, was done for exhibitions! I know these guys, they can do a lot of improv...

I will try to keep it simple, when the tire hits the body especially locked and under shock load it causes that tire to abruptly stop with power still being supplied to the small drive gear on the axle. This turns the small gear(upper drive axle gear) into a high torque Sun gear and the larger driv...

compunerdy wrote:He probably needs them after looking at the videos..

How about some bump stops..

Are there examples of installation? And what is the purpose? Do not allow the suspension to work in the upper direction?

Instead of new pins, new springs, lifts and mods - what about new, smaller tires? Generally the tires are much more expensive than the springs and shock absorbers .. so I'll change them when they will be worn out.. And one more... no one has explained how the contact with the body leads to the dest...

After looking at your video I can plainly see your tires are too tall . If they exceed 34"(86.36CM) they will contact the body under articulation, especially the fronts while turning. The lack of locktite on the mating surface is also a factor. The Red Bull truck tires were too tall, they rubb...

compunerdy wrote:Crazy stuff.. I think I would have had to change my undies...

Have you ever rolled it yet?

Thank God i don't roll yet, but felt on the side a couple of times!

I also need to think about the weak point in the transmission which will be broken in the first, but it seems odd that this is happening with the destruction of the axle's body! It will be better to make a lighter locking bolt so that it whould be cut off in case of overloading without destroying th...

Look like new inside) What is Ex2 upgrade?

krick3tt wrote:If you have the ability to do this kind of work...you can just make a truck out of scraps. That is great.

Unfortunately, I can only pay to someone who will do this kind of work!

Here is a method of strengthening the front axle, which made by ​​my friend! He made a new bolt for the spring cup, which has the same cone, an inch longer than the original, and the same length as the locking bolt down! Then he drilled a hole in the inner part of the axle...Working good yet! 8) One...

looks like it will work Website says: Loosening torque : 32Nm = 283 in-pounds Prevailing torque : 39Nm = 345 in-pounds http://www.liqui-moly.de/liquimoly/mediendb.nsf/gfx2/3806%20Buchsen-%20und%20Lagerbefestigung.pdf/$file/3806%20Buchsen-%20und%20Lagerbefestigung.pdf and Loctite red 263 is 290/290 ...

I think that in the previous repair there was no loctite using! My mechanic suggests to brew axle's tubes in several places welding small areas so that they could then be cut at the case of repair! In his opinion, this will further strengthen the attachment and if it starts cranking, it can be seen ...