Search found 1029 matches
- Tue Nov 17, 2009 9:29 pm
- Forum: Owner builds, customizations & accessories
- Topic: After market seats - what did you use?
- Replies: 27
- Views: 15209
- Tue Nov 17, 2009 6:46 pm
- Forum: Owner builds, customizations & accessories
- Topic: After market seats - what did you use?
- Replies: 27
- Views: 15209
I have done 8 sets of aftermarket seats for people. By far the best seats have come out of Honda car products. I personally have the CRX seats in my 710 and prelude seats in my 712. Geo seats also work although not as low a profile as Honda. About half of the sets I have done were on stock frames. T...
- Thu Nov 12, 2009 7:41 pm
- Forum: Body & Interior
- Topic: Swiss Flag Decal
- Replies: 24
- Views: 25253
- Thu Nov 12, 2009 7:39 pm
- Forum: Drivetrain
- Topic: clutch?
- Replies: 20
- Views: 9463
- Wed Nov 11, 2009 7:30 pm
- Forum: General chat
- Topic: things are good in pinz world again
- Replies: 1
- Views: 1159
things are good in pinz world again
After a rough month things are good in my pinz world again. My 712 had a bad coil which was hard to find and let a friends son drive my 712 pinz for short time and wouldn't you know it clutch had a total failure. My 710 was down with a #4 spark plug blown out of its cylinder and awaiting its new eng...
- Mon Nov 02, 2009 3:56 pm
- Forum: Engine
- Topic: Tail pipe for EI muffler?
- Replies: 9
- Views: 5518
First you are correct with your statements for a, current, water cooled, higher horse powered motor. The pinz runs an old air cooled motor, lower gear ratios, lower top end rpm's and relies on torque for performance not horse power. The pinz is not a speed racer nor a diesel so moving air is not as ...
- Fri Oct 30, 2009 12:55 pm
- Forum: Engine
- Topic: Tail pipe for EI muffler?
- Replies: 9
- Views: 5518
- Thu Oct 29, 2009 5:00 am
- Forum: OTHER 4x4's
- Topic: (OT) The maddness continues
- Replies: 11
- Views: 1590
- Thu Oct 29, 2009 4:44 am
- Forum: Engine
- Topic: Tail pipe for EI muffler?
- Replies: 9
- Views: 5518
When it became time for a new muffler on my 710 I took it to a local muffler shop. I had them install a high resistance muffler and tailpipe fittings to the location shown in attached photo. Total cost was $135.00 for muffler, tailpipe, hangers and labor. My 712 was $200 and it ends out the rear of ...