THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Sorry, I meant the bearing on the front right half shaft, not in the drive shaft. It was late...

Is it possible to remove the front drive shaft through the reduction gear housing without removing the whole axle assembly? I need to replace the bearing.

The SOCOM 718s were beefed up to haul as much as 7,000lbs. in the field, so indeed the front springs are much stiffer than stock.

Listed as "Suspension Strip" 716.187.1302/55, I need the mounting strip that clamps the soft top to the top of the windshield. Thanks

I would like to buy this top if you still have it.

I've heard Chevron is good but hard to find in Ohio.

PM sent. Seriously interested. Can you send photos to: awise1@cinci.rr.com

Thanks

I hate it when my fuel injector dies in the middle of dessert. Especially a banana split.

Again, no price or location???

No price or location? Red flags in my book.

I'm not an electric guy. I'm wanting to install a RAK15 ration/water heater in my 710M. It requires 24vdc/15amps. Can I wire it up to the accessory plug behind the front right seat, or should I run a separate lead directly off the batteries with a fuse? Is a 15amp draw a big deal?

Turns out my cover plates for the jets were simply loose.

After 7 years of zero problems, my carbs both started gushing gas out the sides. It was running fine before this. Did both my float valves just give up?

Thanks for everyone's help. Removed the axle arm today and ready to install the new axle.

Jim, can I give you a call with a few questions?

Alan Wise