Pinzi SSI

Engine troubles? Try here.
User avatar
Andre
United States of America
Posts: 867
Joined: Fri May 12, 2006 10:41 pm
Location: Winnsboro Tx
Contact:

Re: Pinzi SSI

Post by Andre » Sun Jan 21, 2018 8:51 pm

Compression test would be a good idea as well.
Fat Fabrications
289 County Road 1673
Mount Pleasant, TX. 75455
fatfabrications@yahoo.com
(903) 717-4018 shop
(951) 765-7224 cell

74 710m and (1) pinz trailer

whitesik
United States of America
Posts: 102
Joined: Thu Apr 02, 2015 2:11 pm
Location: Indiana, U.S.A.

Re: Pinzi SSI

Post by whitesik » Sun Jan 21, 2018 9:12 pm

Thanks,
Andre, compression has been good on all but I will check it again.

I have put a jumper bypassing the 4500 rpm unit already. It remains in place.

Alternator has good output.

I have not specifically load tested the batteries. will do. Starter runs well.

Again, thanks!
75 Swiss 710K
Not so new owner but still a novice

pinzinator
Posts: 759
Joined: Thu Jul 29, 2004 3:12 pm
Location: Indio, California

Re: Pinzi SSI

Post by pinzinator » Sun May 13, 2018 5:28 pm

3D printing will soon be phased in as way of producing a part for the PinzSSI ignition system. The engagement foot at the lower end of the module shaft is in the experimental stage, I will be installing it into my Pinzgauer this weekend. The material is supposed to be able to take extreme heat and stress, and is nylon based. In the photos you can see how the original aluminum foot compares to the 3D part.
IMG_0836.JPG
IMG_0836.JPG (394.04 KiB) Viewed 233 times
Attachments
IMG_0837.JPG
IMG_0837.JPG (363.8 KiB) Viewed 233 times

Post Reply