Choke (fuel enrichment) screw up?
Posted: Sun Apr 05, 2020 1:25 pm
So I have been working on getting my 73 710 back on the road after years of sitting- so went through the "red death", then added the solid state ignition module, then rebuilt the carbs, replaced one shut off solenoid. The problem is i think I messed up the chokes when i put them back together. Initially i thought it was a float height problem (yes, on the list)
It starts up, but idles crazy fast with choke off, when i open the choke it slows a little, but still way to fast, It also sputters when when you give it some gas. I'm getting ready to open up the chokes and look- (I assume I put them in both the same way)Is it possible to put the plates in backwards or upside down or just "in wrong".
so................... looking for any guidance on the set up.
It starts up, but idles crazy fast with choke off, when i open the choke it slows a little, but still way to fast, It also sputters when when you give it some gas. I'm getting ready to open up the chokes and look- (I assume I put them in both the same way)Is it possible to put the plates in backwards or upside down or just "in wrong".
so................... looking for any guidance on the set up.