I am changing out a cracked/leaking factory axle boot with a split type and when I removed the original, a small metal angle piece of metal fell out from the area where the axle casing mates to the stop ring. I previously replaced another boot and don't remember seeing this before. Can somebody please tell me what this piece might be for and the orientation of it? If I am identifying it correctly, it appears to be #21, Group 3-10-24 of the parts manual. It has a curved radius or arc on one edge and is about 2" long.
If is is needed/required, should I take apart the other side to make sure it is there?
Thanks,
Doug
metal angle piece behind factory angle boot
-
- Posts: 10
- Joined: Mon May 24, 2004 8:41 am
- Location: Woodbridge, VA
- TechMOGogy
- Posts: 2831
- Joined: Wed Feb 01, 2012 11:39 am
- Location: Ontario, Canada
Re: metal angle piece behind factory angle boot
Just adding in the photo so help may be faster.
Unfortunately I have nothing to offer at this point
Unfortunately I have nothing to offer at this point
- Attachments
-
- 11-7-2013 12-49-08 PM.png (42.1 KiB) Viewed 2723 times
72 Pathfinder | 75 710M 2.7i | 96 350GDT Worker
Re: metal angle piece behind factory angle boot
it goes inside #17 to keep the rubber ring tight to the flat bottom portion of the axle tube.
Fat Fabrications
2993 FM 1647
Winnsboro, TX. 75494
fatfabrications@yahoo.com
(903) 365-2332 shop
(951) 765-7224 mobile
Facebook.com/dokapinz6x6
Www.fatfabrications.com
2993 FM 1647
Winnsboro, TX. 75494
fatfabrications@yahoo.com
(903) 365-2332 shop
(951) 765-7224 mobile
Facebook.com/dokapinz6x6
Www.fatfabrications.com
-
- Posts: 206
- Joined: Mon Sep 28, 2009 11:36 am
- Location: WHIDBEY ISLAND
Re: metal angle piece behind factory angle boot
I was told by Jim L. that it is not a necessary piece..that if you don't have one don't worry about it. I will try to find the post 'I remember now when i ordered the whole repair kit (710 1 32 260 9 number (3) in the drawing) that little angle wasn't included. I asked about it on here and as I remember Jim L said no problem