I've got more problems with a VDO speedo. It's one of them with "PINZGAUER" script on the face.
VDO instructions show 3 leads from the Hall sensor mounted on the end of the speedo cable. But this Hall sensor only has 2 leads. Any ideas?
FWIW, currently, the black lead from the Hall sensor goes to pin 8 and the white lead from the Hall sensor goes to pin 2, both as shown on this schematic:
http://www.egauges.com/pdf/vdo/0-515-012-051.pdf
vdo speedo question
-
- Posts: 1776
- Joined: Fri Apr 16, 2004 8:08 am
- Location: Blue Mounds, WI
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
-
- Posts: 1776
- Joined: Fri Apr 16, 2004 8:08 am
- Location: Blue Mounds, WI
Thanks guys,
Paul
Patrick asked me to send a photo. Apparently they used some different models of senders.
The VDO info I've got also only shows a 3-wire sensor.
Jim
The two wires seem to come out of a rubber strain-relief, or some such thing. I didn't see any evidence of a third wire, but I'll double check today.
Paul U
Paul
Patrick asked me to send a photo. Apparently they used some different models of senders.
The VDO info I've got also only shows a 3-wire sensor.
Jim
The two wires seem to come out of a rubber strain-relief, or some such thing. I didn't see any evidence of a third wire, but I'll double check today.
Paul U