VIC-1, Dual Antennas, Radio racks in my 710M radio truck

Dedicated to the memory and knowledge shared by Jim Mettler - All things relating to the flow of electrons in a Pinz.
Post Reply
swashplate

VIC-1, Dual Antennas, Radio racks in my 710M radio truck

Post by swashplate »

I just purchased a 710M "radio truck" in San Diego, CA and I have a few questions
I think I have everything BUT the Radio R/T.

1-Any reference/diagrams for the VIC-1 intercom set?
a-ipod hookup?
b-CB hookup?
c-phone hookup?

2-Any photos/reference for the racks in the back?
a-I have one extra rack and don't know where it goes.
b-I have the two boxes in the forward left and right side with one rack that goes between it ,base rack for the left
rear, and tall rack for the right rear that are all installed

3- I have both antennas with the mounts that go through the front and left sides of canvas. I also have boxes of the tie down straps and antenna balls. But I dont know the correct tie down procedure, anybody have a reference/photo?
undysworld
Norway
Posts: 1776
Joined: Fri Apr 16, 2004 8:08 am
Location: Blue Mounds, WI

Re: VIC-1, Dual Antennas, Radio racks in my 710M radio truck

Post by undysworld »

I got VIC-1 hookup diagrams from the Yahoo VIC-1 group.
swashplate

Re: VIC-1, Dual Antennas, Radio racks in my 710M radio truck

Post by swashplate »

undysworld wrote:I got VIC-1 hookup diagrams from the Yahoo VIC-1 group.
Thank you, I'll try there too.....did you mean the "mvintercom" group ?
undysworld
Norway
Posts: 1776
Joined: Fri Apr 16, 2004 8:08 am
Location: Blue Mounds, WI

Re: VIC-1, Dual Antennas, Radio racks in my 710M radio truck

Post by undysworld »

That was probably it. It's been several years, with a lot of stuff in between...
Post Reply