The Weber Hydraulik jack off of my Pinz has finally given up the ghost. The local hydraulic shop did a rebuild with new seals, but it is still leaking. Now is the time to stop the money hemorrhage and get something new. However, I can't find another working used Weber anywhere.
Are there any other good jacks that work with the Pinz? I tried a Hi-Lift, but it was unstable and dangerous.
Thanks for the info.
Pinz Hydraulic Jack Replacement
Pinz Hydraulic Jack Replacement
Thanks,
John Cotner
1946 Willys CJ-2a
Elizabethton, TN
John Cotner
1946 Willys CJ-2a
Elizabethton, TN
-
- Posts: 917
- Joined: Thu Jul 29, 2004 3:12 pm
- Location: Indio, California
Take your pick
http://search.harborfreight.com/cpisear ... &Submit=Go
The 6-ton or the 8-ton should work OK.
http://search.harborfreight.com/cpisear ... &Submit=Go
The 6-ton or the 8-ton should work OK.
- audiocontr
- Posts: 1868
- Joined: Fri May 01, 2009 1:30 pm
- Location: Buffalo NY
Under the rounded portion of the axle half shaft. There is a flat portion down there that looks like it would work with a normal jack, but I was reluctant to jack there. I'm finding the same problem with jacks around here: not enough height. The tallest I've found are around 17". And even with a 6x6 underneath, it would still be only be 22 1/2"
Thanks,
John Cotner
1946 Willys CJ-2a
Elizabethton, TN
John Cotner
1946 Willys CJ-2a
Elizabethton, TN
-
- Posts: 1776
- Joined: Fri Apr 16, 2004 8:08 am
- Location: Blue Mounds, WI