THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Look at past discussion of replacing door gaskets and most links are outdated. Does anyone have recent supplier of door gaskets materials?

Thanks,

Jake

Paul, any experience with this gasket material?

Yes, I've done 4-6 doors with it. It matches the original well but does require some careful miter cuts for the corners. You'll also need an appropriate glue for the corners. I used some Super Glue that was meant for use with rubber, Loctite 414 I think. 3M Weatherstrip Adhesive (black) worked well for gluing the weatherstrip to the door frame.

I seem to remember a forum thread from a few years back about a nice technique for mitering the corners. Probably worth a search.

Here is the thread Paul mentioned.
I had it bookmarked so easy to find: viewtopic.php?f=17&t=7533&start=15
I used 3M for all edges vs super glue.
Here are some photos from when I did it: viewtopic.php?f=17&t=7533&p=82664&hilit=seal#p82664

I recent put some sell adhesive weather stripping on mine and seems to working quite well. About $2 a roll at Home Depot.

As it so happens I just did two more doors with my
Miter and the SAV material. I had to read my old
Posting as I forgot the details still comes out
Nice and square.

I used some 3M self-adhesive weather stripping at the hardware store. Works well.

Doug308,

I'd be curious to see a cross section of that 3M weather stripping,
or a reference to it. Can you also send a PIX of you door with this
in place.