Page 1 of 1
Best way to make door weatherstripping corners?
Posted: Fri Aug 21, 2009 11:18 pm
by McCall Pinz
I just weatherstripped my driver's side door and am not happy with the corners. I tried to miter them with some scissors, but there are gaps. Is there a better way or is this as good as it gets? Is there a way to cut the inside edge and keep the lip continuous?
Posted: Sun Aug 23, 2009 7:09 pm
by todds112
That's what I did too. I overlapped both ends together and cut them at the same time. I used super glue (the gel kind) and it held them pretty well.
weatherstriping
Posted: Mon Aug 24, 2009 9:21 am
by krick3tt
It's just like cutting crown moulding. I used an xacto knife and then super glue. The nice part is that there is only one corner on the bottom.
I used the preformed weather striping for the tops. Still have the bottoms left over.
Morris