The guys at LineX took out a bunch of hardware from the bed of my 712M before doing the LineX, and now I'm not sure how the hardware goes back in! I do have the parts manual and it shows me the general idea of where things go, but I'm still not sure. Any help (or better yet, photos of YOUR Pinz 712M truck bed) is greatly appreciated! I basically have 2 questions--see photos for details of how I THINK these things go, but I'm really not sure... Thanks. -Jon
I have 1 of the 2 "things" screwed in here. BTW, what are these used for?
Once again, I have 1 of the 2 screws attached here. Does the bracket go in front of or behind the truck bed? Also, what is this for?
This shows the other side where the 2 holes are BEFORE I tried to mount the bracket.
This is just a wider angle shot to make it easier to orient you to where I am talking about on the truck. Thanks!
Bed of my 712M done w/ LineX--now I have hardware problems!
- Jon_Gilbart
- Posts: 60
- Joined: Sun Dec 07, 2008 6:44 pm
- Location: Maryland
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact: