front seat

Build projects, things that guys have come up with to make a Pinz better (or worse?) and aftermarket add-ons.
Post Reply
Derrickbwg
United States of America
Posts: 103
Joined: Sat Dec 16, 2017 8:09 pm
Location: TN

front seat

Post by Derrickbwg » Wed Feb 10, 2021 8:41 am

Its 19" wide

Ive just tacked it in to try on stock lower frame using some rail adapters. head to roll bar bumper height is same as stock, but the side is quite a bit higher. IRemoving the tabs from seat and welding straight tube-to-tube (seat frame to lower tube frame) would help in lowering that height. Its not bad at all for me but i'm only 170lbs so its hardly noticeable. If you slide the seat all the way to the rear it helps clearing the side on entry. It does not fold or recline but its so light it comes out with ease and clears the steering wheel easily. I dont think it will fit well in my k with the heater due to the reclined angle of seat back.



prp.jpg
prp.jpg (1.73 MiB) Viewed 739 times
Last edited by Derrickbwg on Tue Mar 02, 2021 7:16 am, edited 3 times in total.
1975 710K
1974 710M
2018 G63

Derrickbwg
United States of America
Posts: 103
Joined: Sat Dec 16, 2017 8:09 pm
Location: TN

Re: My front seat quest

Post by Derrickbwg » Wed Feb 10, 2021 8:47 am

some more
prp3.jpg
prp3.jpg (1.81 MiB) Viewed 736 times
1975 710K
1974 710M
2018 G63

Post Reply