Page 1 of 1
Looking for Dyno in S.F. Bay area
Posted: Sun Aug 21, 2016 8:46 pm
by bikmakr
I'm finally approaching the end of my ITB EFI project and have worked most of the bugs out of the tune. Now I need to run some WOT draws on a dyno. Does anyone know of a shop that can rack a 712, preferably in the SF Bay area?
Thanks
Re: Looking for Dyno in S.F. Bay area
Posted: Sun Aug 21, 2016 9:07 pm
by rmel
I looked, called, begged. No one interested in doing pulls on anything but Ferrari's and Lamborghini's in the Bay Area
Ending up with John @ Outfront Motor Sports doing the pulls for me. John is the man if you want the experience and
ultimate tune job. It's a long drive to Buena Park CA but well worth it. A side trip if'n your going to Mogfest at Calico
What ECU you running? Might be able to at least get you in the pall park on tuning.
ron
Re: Looking for Dyno in S.F. Bay area
Posted: Sun Aug 21, 2016 9:19 pm
by bikmakr
I'm running the new Megasquirt 3 PRO. It's incredibly versatile for running fully a sequential ITB system.
Re: Looking for Dyno in S.F. Bay area
Posted: Sun Aug 21, 2016 10:15 pm
by McCall Pinz
looking good. Nice solution to fix the unequal length intakes.
Re: Looking for Dyno in S.F. Bay area
Posted: Mon Aug 22, 2016 10:18 am
by Jimm391730
You will need to remove the wheels on one of the rear axles (IIRC, I took the wheels off the middle axle). Put two lugnuts on to hold the drums in place. The drums will hang with about 1-2" clearance, if your limiting straps are intact. Outfront can only dyno one axle. They have done many Pinzis.