Rear 2" receiver mount
Posted: Mon Oct 04, 2021 11:25 pm
My Pinz came with a buggered up 2" receiver mount for the rear tail cone so over the weekend I fab'd up a new one.
I cut the old receiver off but reused it's baseplate then added the new 6" receiver and some gussets. Can't go wrong with gussets . New 10.9 hardware with thick washers are ready to go once the paint is cured.
I cut the old receiver off but reused it's baseplate then added the new 6" receiver and some gussets. Can't go wrong with gussets . New 10.9 hardware with thick washers are ready to go once the paint is cured.