Flange Leak

Issues pertaining to the TGB/C30X series engine and driveline issues
Post Reply
Uli-RT
Germany
Posts: 71
Joined: Wed May 16, 2012 7:27 am
Location: Baden-Württemberg

Flange Leak

Post by Uli-RT »

Hello everybody,
should anyone have problems with flange leaks,
there is a solution at SKF.
greetings
Uli

Image

Image

Image
Jim Molloy
United States of America
Posts: 364
Joined: Sun May 30, 2004 2:16 pm
Location: Sheridan, Oregon
Contact:

Re: Flange Leak

Post by Jim Molloy »

Uli,
Thank your for the reminder. Do you have the SKF part number? The dimensions? The cost? Do you plan to use the same size seal or one with a slightly larger internal diameter? Was the sleeve a simple press fit or did you heat the sleeve/chill the stub axle prior to installation.

Jim Molloy
Waldersee Farm
http://www.northwestmogfest.com
Uli-RT
Germany
Posts: 71
Joined: Wed May 16, 2012 7:27 am
Location: Baden-Württemberg

Re: Flange Leak

Post by Uli-RT »

Hello Jim,
I bought a complete set for € 40. The shaft seal has the original size. The repair sleeve is very thin. Installation tool is included. Takes a few minutes. Very easy to assemble. Under no circumstances make it hot.
The parts are available from Claas (Friese in the C303.de Forum) in Germany. Not easy to get.
greetings
Uli
Jim Molloy
United States of America
Posts: 364
Joined: Sun May 30, 2004 2:16 pm
Location: Sheridan, Oregon
Contact:

Re: Flange Leak

Post by Jim Molloy »

Hi Uli,
Thank you for the information.
Take care.
Jim
Post Reply