RHD C303

russiow · Post by **russiow** » Mon Jul 03, 2006 2:48 pm

Hi guys,

Im a bit new to all this and i am trying to find my feet!!

Whats the chances of finding a RHD model??

Has anyone fitted Turbo diesel engines with an auto like pinz?

Russ

lindenengineering · Post by **lindenengineering** » Tue Jul 04, 2006 10:43 pm

In short we have looked at doing a right hooker, it looks like it can be done although we didn't see much use in that project since we need left hookers in the USA.

Currently we have looked at a Volvo Penta engine (ex marine application), Merb M617 T and we are about to stuff a Landrover 4 litre petrol c/w its auto box into a unit we have. Obviously if the V8 will fit then the TD5 LR diesel will fit no sweat.
Dennis

Jim Molloy · Post by **Jim Molloy** » Wed Jul 05, 2006 8:21 am

Dennis,

Which Volvo Penta engine were you considering? I know the MB OM617A turbo is a relatively high rpm engine and should allow for no loss of top speed in a Volvo C-series truck. Is the Volvo Penta also a high revving diesel?

Take care.

Jim Molloy
Waldersee Farm
http://www.northwestmogfest.com
http://www.volvo4x4.com

lindenengineering · Post by **lindenengineering** » Sun Jul 09, 2006 12:35 pm

Jim
The diesel conversion really dictates the use of an O/D transmission.
Dennis

isle of man · Post by **isle of man** » Sun Jul 09, 2006 2:15 pm

i'm considering a 4 cylinder 3500 nissan diesel turbo and land rover automatic because the rear tank cross beam restricts the gearbox that can be used....and when i looked at the girth a v8 appeared as it would not fit without some major changes to the tunnel or dropping the engine which creates a whole new set of problems..........

peter henry

lindenengineering · Post by **lindenengineering** » Sun Jul 09, 2006 4:24 pm

Currently we have done "physical offer ups" to the Volvo chassis including the Chev V6, "squeezed a Chev V8" in there and have done a LR offer up as my past post indicated.
Dennis

isle of man · Post by **isle of man** » Mon Jul 10, 2006 1:21 am

good luck........

peter henry

lindenengineering · Post by **lindenengineering** » Mon Jul 10, 2006 7:46 am

Well thanks.
Much appreciated.
Regards
Dennis