Parts Needed

kc4mne · Post by **kc4mne** » Sun Feb 11, 2007 9:03 am

Hello

Man nobody' posts down here!!

Looking for a 639991-9 Diaphram for the vacuum servo that activates the transfer case from AWD to RWD.

Also may need two CV joints for the front axle

Manny

lindenengineering · Post by **lindenengineering** » Sun Feb 11, 2007 9:48 am

Manny
I have the cylinder/diaphragm assy.

The cv joints, do you need the boots or the actual cv joints themselves?
Dennis

kc4mne · Post by **kc4mne** » Sun Feb 11, 2007 11:26 am

Thats Great

I am going to need the whole assembly, looked at it today and the housing is also cracked

Also I have a bad bearing on the transfer case on the front shaft output.

If wife gives me time I will start dissasembly today to start exploring.

keep you informed. I would imagine you also have a complete transfer case should I end up needing one.

This is for a 6x6 Tgb13 that I just had shipped over from Sweden. Picked it up at port of Jacksonville, FL on Friday. Drove it back to Ft Lauderdale yesterday.

I thought I had a bad CV joint on front axle because I heard a clanking noise while turning, remember I had 6x6 permanantely engaged. But after spinning wheels with truck on jack stands I think it is comming from the transfer case.

Manny

lindenengineering · Post by **lindenengineering** » Sun Feb 11, 2007 11:52 am

Manny
I have the bits give me a call.
Dennis
720 344 1877