EFI
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
I hope to have it running by weekend.
But until then, here are a couple pics of the completed ECU center.
First image is the 24 to 12v starter signal circuit. It is 2 1K 1/4 watt resistors in series, one end is 24v signal, other end is ground(earth for the UK guys), 12v is tapped from between resistors to feed computer starting enrichment signal.
Harness access locations.
ECU Center ready to install.
ECU in place.
And one of the heat shield mod to fit TPS connector.
Carbs converted to throttle body with TPS
Enjoy more to come
But until then, here are a couple pics of the completed ECU center.
First image is the 24 to 12v starter signal circuit. It is 2 1K 1/4 watt resistors in series, one end is 24v signal, other end is ground(earth for the UK guys), 12v is tapped from between resistors to feed computer starting enrichment signal.
Harness access locations.
ECU Center ready to install.
ECU in place.
And one of the heat shield mod to fit TPS connector.
Carbs converted to throttle body with TPS
Enjoy more to come
-
- Posts: 36
- Joined: Wed Feb 04, 2009 1:44 am
- Location: Belgium
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact:
Here are a few more pic's.
First one is starter signal resistor pack install point(black wire from starter to solenoid).
Next, remove drain plug from gas tank, install 1/4"NPT to 5/16" line fitting adaptor(use only LIQUID TEFLON SEALANT).
Bend and fit 5/16"return line
More to come..........................................................................
First one is starter signal resistor pack install point(black wire from starter to solenoid).
Next, remove drain plug from gas tank, install 1/4"NPT to 5/16" line fitting adaptor(use only LIQUID TEFLON SEALANT).
Bend and fit 5/16"return line
More to come..........................................................................
-
- Posts: 1704
- Joined: Wed Apr 14, 2004 3:42 pm
- Location: San Bernardino Ca
- Contact: