Some roof dimensions, please?
Posted: Thu Jan 05, 2012 1:40 pm
Next time one of you 303 owners are near your truck with a tape measure, can you please take a couple measurements?
I need the exact length of the rear roof panel as measured from the seam from where it attaches to the cab section, back to where the roof panel attaches to the rear section. (Looks like it's about a foot forward from the back roof edge).
Also, if you would, a couple width measurements. One the total width of the roof panel. I think by opening the two rear side doors, shoul be easier that getting up in it.
the last one I need is how long the cross members are on the underside of the roof, as measured between the top of the angle pieces that are inside the curved side corners.
Basically I'm just curious about how big a hole I can cut out for the FlipPac, and still have some of the internal framework left. I know I'll have to add some strength, but it seems like I'll have enough room.
Thanks, Folks!
I need the exact length of the rear roof panel as measured from the seam from where it attaches to the cab section, back to where the roof panel attaches to the rear section. (Looks like it's about a foot forward from the back roof edge).
Also, if you would, a couple width measurements. One the total width of the roof panel. I think by opening the two rear side doors, shoul be easier that getting up in it.
the last one I need is how long the cross members are on the underside of the roof, as measured between the top of the angle pieces that are inside the curved side corners.
Basically I'm just curious about how big a hole I can cut out for the FlipPac, and still have some of the internal framework left. I know I'll have to add some strength, but it seems like I'll have enough room.
Thanks, Folks!