Hello to all,
For the past few months, I have been working with Power Arc Ignitions in Des Moines, IA in prototyping a more modern ignition system. Progress has been slow but steady. The primary obstacle has been the lack of direct access of the engineers to an actual intact Volvo C-series vehicle. Photos just do not do justice to advance the project quickly. It is this issue that I would like to resolve once and for all. We are looking for someone in the upper Midwest area that would be willing to allow a Power Arc engineer to inspect and take measurements of a standard B30A motor with all its standard ancillaries in place to insure proper fitment of their product. I do not know just how far their personnel would be willing to travel but I guess we will find out.
Thank you!
Take care.
Jim Molloy
Waldersee Farm
Sheridan, Oregon
http://www.northwestmogfest.com
Power Arc Ignition prototype
-
- Posts: 364
- Joined: Sun May 30, 2004 2:16 pm
- Location: Sheridan, Oregon
- Contact:
Re: Power Arc Ignition prototype
Well, if the engineer is willing to go to the East Coast, (he, she, they) can mess around with my 303. It's about as stock and unmolested as you'll find. I understand there is another C303 in Boston also.
Rick
Rick
-
- Posts: 364
- Joined: Sun May 30, 2004 2:16 pm
- Location: Sheridan, Oregon
- Contact:
Re: Power Arc Ignition prototype
Rick,
Thank you for the offer. I will pass along your invitation. They are also well to come to the west coast as well.
We shall see.
Take care.
Jim
Thank you for the offer. I will pass along your invitation. They are also well to come to the west coast as well.
We shall see.
Take care.
Jim