Boring cylinders

Old forum posts ending on Oct 21 '09

Moderator: TechMOGogy

Locked
712 Walt
Posts: 14
Joined: Fri Apr 16, 2004 4:54 pm
Location: Oceanside, California

Boring cylinders

Post by 712 Walt »

Had a valve drop into the #3 cylinder. Had to bore out cylinder #3 to 93.00 mm before it cleaned up. Is it necessary to bore out the other cyliners to match? They are in the 92.20 to 92.31 mm range and I am considering boring them out to 92.50mm and replacing the pistons.
ExpeditionImports
United States of America
Posts: 436
Joined: Wed Apr 14, 2004 2:53 pm
Location: Vallejo, CA
Contact:

Post by ExpeditionImports »

Normal repair procedures would be to match your bore sizes.

Cheers,

Scott
Expedition Imports Corporation
Vallejo, California
www.expedition-imports.com
"You didn't buy a Chevy..." "Hows that Amazon tech support working out...."
Profpinz
Australia
Posts: 1056
Joined: Sat Apr 17, 2004 7:08 pm
Location: Melbourne, AUSTRALIA
Contact:

Post by Profpinz »

I wouldn't run "non-matched" cc's/volumes, but I've known a few pretty rough mechanics over the years whom I'm sure wouldn't think twice about doing it. :wink: :roll: :D :D
Peter

1974, 712 6X6 Pinzgauer
1983, 710-1.6 4X4 Pinzgauer
1997, 718 6X6 Pinzgauer (in pieces)
1971, 700 Haflinger
1974, 703 LWB Haflinger
2001, Range Rover

http://www.ozpinz.com
pinzinator
Posts: 919
Joined: Thu Jul 29, 2004 3:12 pm
Location: Indio, California

Post by pinzinator »

I agree with Scott and the Professor, the rotating assembly would be thrown out of balance if you proceed as planned. The piston and rings from each cylinder should weigh the same (assembled), within a few grains of each other. Not sure what the exact recommended tolerance should be.
Locked