Old forum posts ending on Oct 21 '09
- Posts: 1850
- Joined: Fri May 01, 2009 1:30 pm
- Location: Toronto Regional Area
Should i kick myself? I was following the directions in the manual, but some posts here mention to not touch the mixture screws. While playing with the carbs, i twisted the mixture adjustment screws in snug, then backed out the same number of turns it took to twist them in. basically 1.5 full rotations.
Would i have caused damage to the carbs doing this?
- Posts: 847
- Joined: Thu Apr 15, 2004 9:46 pm
- Location: Gilbert, Az.
If your definition of snug is just when it stops,then your golden. Sometimes over the years the taper of the screw will get a step in it making for a less accurate adjustment.
Stock means no imagination!
Volvo TGB1317, .95% Morphed!
- Posts: 1553
- Joined: Sun Jan 21, 2007 7:52 pm
- Location: Wichita, Kansas
Should i kick myself
Go ahead kick your self.
I struggled with the carbs just about the whole time they were installed. Big pain i'm glade there gone.
- Posts: 121
- Joined: Wed Aug 13, 2008 2:00 pm
- Location: ELkhart, in
If it ain't broke, why would you ever fix it?? I think a good kicking is in order!! Form a line to the right!!!
Did that help??
- Posts: 445
- Joined: Mon Jun 02, 2008 8:34 pm
- Location: slc,scruz,chico,bldr,kalalau,flag,sb
sounds like it was very "broke", tho. yes?
isn't the balancer (snail shaped vacuum tool) an essential tool?
"it is not in the best interest of the shepherd to breed smarter sheep." ~ author unknown
press any key to continue or any other key to quit. ~author confidential