Pinzgauer Rescue

All things not relating to the other forums.
United States of America
Posts: 13
Joined: Wed Sep 16, 2020 8:05 am

Re: Pinzgauer Rescue

Post by randymir » Mon Sep 21, 2020 8:59 pm

Thanks for the info Ron!!

I'll post as I go along.
'74 - 710K

User avatar
United States of America
Posts: 1192
Joined: Sun Sep 25, 2011 12:19 pm
Location: Woodside, CA

Re: Pinzgauer Rescue

Post by rmel » Thu Apr 01, 2021 10:29 pm

One of the last projects I had planned for this 712 is a Overhead Console. I find
the "M" tight on space for added electronics so thus the need for an overhead.

It's done but waiting for the ICOM IC-7100 Transceiver which is on back-order.
You will see a cavity where the Radio control head will be mounted.

I also added several Gauges I find very useful; AFR, Exhaust Pyrometer on #3,
Cylinder Head Temp on #2 (ala Porche 911 style), Oil Pressure, and Aux Battery
Voltage meter. Oh, and a back-up Camera which is almost necessary in traffic,
given the limited rear view in a 712.
Overhead1.jpg (535.3 KiB) Viewed 128 times
This was fabricated from 0.128 and 0.090 Aluminum stock. I decided to braze
in the Gauge mounting panel. In retrospect I'm getting a spool gun and some
Argon. Did all the bends on a Swag Off Road Finger brake.
Guage-panel.jpg (636.37 KiB) Viewed 128 times
Just FYI, the Bosch Oil Pressure switch can be replaced with a VDO pressure
sender that supports both a pressure switch and an analog output for the Gauge.
The body size of this unit is about 1.5" in diameter -- it may or may not fit,
expect some interference with the Oil dip stick tube. I did have to elongate the
mounting hole -- a bit of a tight fit but OK. Note the thread is M10 x 1 K.
The "K" designates a tapered thread similar to NPT. So thread dope no washer.
Oil pressuer sender.jpg
Oil pressuer sender.jpg (772.69 KiB) Viewed 128 times
Now time to hit the trails.
Puller: 71' 710K 2.7L EFI aka Mozo
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712M

Driver: Ron // KO0Q

Post Reply