should anyone have problems with flange leaks,
there is a solution at SKF.
greetings
Uli
Flange Leak
Flange Leak
Hello everybody,
should anyone have problems with flange leaks,
there is a solution at SKF.
greetings
Uli
should anyone have problems with flange leaks,
there is a solution at SKF.
greetings
Uli
-
Jim Molloy
- Posts: 316
- Joined: Sun May 30, 2004 2:16 pm
- Location: Sheridan, Oregon
- Contact:
Re: Flange Leak
Uli,
Thank your for the reminder. Do you have the SKF part number? The dimensions? The cost? Do you plan to use the same size seal or one with a slightly larger internal diameter? Was the sleeve a simple press fit or did you heat the sleeve/chill the stub axle prior to installation.
Jim Molloy
Waldersee Farm
http://www.northwestmogfest.com
Thank your for the reminder. Do you have the SKF part number? The dimensions? The cost? Do you plan to use the same size seal or one with a slightly larger internal diameter? Was the sleeve a simple press fit or did you heat the sleeve/chill the stub axle prior to installation.
Jim Molloy
Waldersee Farm
http://www.northwestmogfest.com
Re: Flange Leak
Hello Jim,
I bought a complete set for € 40. The shaft seal has the original size. The repair sleeve is very thin. Installation tool is included. Takes a few minutes. Very easy to assemble. Under no circumstances make it hot.
The parts are available from Claas (Friese in the C303.de Forum) in Germany. Not easy to get.
greetings
Uli
I bought a complete set for € 40. The shaft seal has the original size. The repair sleeve is very thin. Installation tool is included. Takes a few minutes. Very easy to assemble. Under no circumstances make it hot.
The parts are available from Claas (Friese in the C303.de Forum) in Germany. Not easy to get.
greetings
Uli
-
Jim Molloy
- Posts: 316
- Joined: Sun May 30, 2004 2:16 pm
- Location: Sheridan, Oregon
- Contact:
Re: Flange Leak
Hi Uli,
Thank you for the information.
Take care.
Jim
Thank you for the information.
Take care.
Jim