Vibrex fasteners
Vibrex fasteners
Anyone know just how the grey plastic bullet end is supposed to fit? I had imagined it to be a tight push-fit, but there's no interference at all between it and the pin...
I guess I could glue it...
Nazdrave,
Rob.
1975 712M (AMB)
1993 Defender 90 (200TDi)
1985 Uaz 469B
1982 Luaz 969 "the Russian Haflinger"
1993 Defender 90 (200TDi)
1985 Uaz 469B
1982 Luaz 969 "the Russian Haflinger"
Re: Vibrex fasteners
Strange, it usually is an interference fit......you could glue it or flatten the end of the pin so as to expand it out a bit.
Peter
1974, 712 6X6 Pinzgauer
1983, 710-1.6 4X4 Pinzgauer
1997, 718 6X6 Pinzgauer (in pieces)
1971, 700 Haflinger
1974, 703 LWB Haflinger
2001, Range Rover
http://www.ozpinz.com
1974, 712 6X6 Pinzgauer
1983, 710-1.6 4X4 Pinzgauer
1997, 718 6X6 Pinzgauer (in pieces)
1971, 700 Haflinger
1974, 703 LWB Haflinger
2001, Range Rover
http://www.ozpinz.com
Re: Vibrex fasteners
I just bought some new Vibrex Locks from SAV and the gray bullet-shaped pieces do NOT interference-fit and stay on. When I removed original locks, the old gray pieces DO fit properly on the new hardware. Meh.