I was concerned about the out of balance situation it would cause. I didn't know if it would cause damage to the bearings, etc. Actually took a few more chunks out of it after that pic was taken. About half the rim is missing on one side of the gear. I was thinking of finding a machine shop that could just take the rest of the rim off. Figured I'ld be into it for just as much as a used one. Live and learn.Jim LaGuardia wrote:There is nothing wrong with re-using that gear. I have found numerous gears with puller damage in that area that were repaired in Europe
While it may throw it out of balance a little, you will never notice it.
Now if the teeth themselves are damaged, then replacement is necessary.
I have been busy lately, or I would have reponded sooner
Mogfest at Calico is just around the corner
Bryan, I guess it's the trade off for all the fun I've been having with her.