Page 3 of 3
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 8:16 am
by mockingbird812
Against my frugal sense, I decided to pull the trigger on the Alfa Romero hardware. I'll be headed back to AZ in a couple weeks and will report what I find. Thanks to all for their help.
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 1:22 pm
by compunerdy
If someone wants to send me a button I will model it up and make it available to be printed at shapeways.
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 1:28 pm
by mockingbird812
Well that is cool. You mean high impact plastic release button created via a high tech printer?
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 1:49 pm
by compunerdy
Basically.. should work fine for the application.
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 2:08 pm
by mockingbird812
Estimate on the per copy cost?
Re: Seat Belt release (orange button)
Posted: Sun Jul 28, 2013 2:36 pm
by compunerdy
Probably around $15 I would guess.
Re: Seat Belt release (orange button)
Posted: Mon Jul 29, 2013 12:18 pm
by mockingbird812
Tim,
I will be on the deck for about 24 hrs when back in AZ (2 weeks from now) where the ebay A. Romero seat belt hardware is being mailed. If I have enuff time to remove the orange button, I will send it to you for this project. Pls pm to me yr mailing address.
Thanks for taking this on Tim. I would suspect that others can take advantage of this new piece too. In AZ our plastic is shorter-lived due to the extreme desert heat.