THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Posted: **Tue Jan 11, 2011 12:59 pm**

The one I've been lent is just a piece of turned steel, would take someone who can do very basic lathework about 10 minutes to make:

Posted: **Tue Jan 11, 2011 3:41 pm**

use a pilot tool for early 10 spline Mercedes or 70-80 Toyota Land cruiser.

Posted: **Tue Jan 11, 2011 3:42 pm**

It's not the most difficult tool to make/obtain - just thought I'd post this for interest' sake.

Clutch alignment tool dimensions (to make your own)