Page 1 of 1
Hose clamp size for intake plenum
Posted: Sun Jun 26, 2011 4:05 pm
by audiocontr
I'm putting together parts to hand off to the new owner of my 712. I'm missing the hose clamps for both carbs to the air intake , and then the large clamp at the intake of the... air intake. Anyone know approximate lengths needed?
Re: Hose clamp size for intake plenum
Posted: Sun Jun 26, 2011 6:41 pm
by undysworld
Mine doesn't have clamps between the carbs and the air box. It has special rubber seals there. See part # 64 below.
I replaced the hose clamp which snugs the rubber seal between the air box and the air filter housing. I believe it was about 4", but all I could find at the local hdwr store was 5". It fit fine. But this one's cheap: See part # 12 below.
Parts photo courtesy of SAV:
http://www.pinzgauer.com/parts.php?cat= ... view=01-35
Here's EI's page:
http://www.expedition-imports.com/c=5iI ... ild_parts/
Re: Hose clamp size for intake plenum
Posted: Sun Jun 26, 2011 9:23 pm
by audiocontr
Thanks, I'll make sure i pick one up for the new owner.