THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

Posted: **Tue Sep 13, 2011 8:24 pm**

I finally got around to replacing my oil cooler, thermostat, seals, and base gasket.

Here's the engine before I got started.

Oil cooler assembly removed. Just remove the 4 nuts on the thermostat housing and lift everything out.

Assembly on the vise. Not IN the vise! 4 nuts hold the cooler onto the thermostat housing.

New parts and gaskets. Now is the time to replace the fuel pump gaskets if they are leaking. Thermostat O-ring not shown.

Everything re-installed. No more leaks! Lucky for me the thermostat only goes in one way, I didn't pay attention when I removed the old one.

Posted: **Tue Sep 13, 2011 8:46 pm**

Wow that's clean!

Posted: **Wed Sep 14, 2011 12:21 pm**

Is that your stash of $100 bills for Pinz parts in that plastic tub.

Like most stuff on the Pinz, pretty easy once you get into it.

Miles

Posted: **Wed Sep 14, 2011 1:20 pm**

Chrome handgrenade

Posted: **Wed Sep 14, 2011 2:19 pm**

$100 bills is a roll of TP, the grenade is a shift knob I bought at O'Reilly's for $6. Might put it in the Pinz, might not.

Oil cooler and seal replacement