Page 1 of 1
Input shafts
Posted: Fri Sep 11, 2015 10:11 pm
by pinzdriver
I have three trany input shafts good tool for lining up your clutch plate befor stabing your trany it looks just like the nose sticking out in front of your trany. Asking $45.00 each shipped. I'll take the first 3 who e-mail me dont reply to this add i'm in phoenix,az.
pinzdriver@cox.net
thanks tony the pinzdoctor
Re: Input shafts
Posted: Mon Sep 28, 2015 6:38 pm
by pinzdriver
pinzdriver wrote:I have three trany input shafts good tool for lining up your clutch plate befor stabing your trany it looks just like the nose sticking out in front of your trany. Asking $45.00 each shipped. I'll take the first 3 who e-mail me dont reply to this add i'm in phoenix,az.
pinzdriver@cox.net
thanks tony the pinzdoctor
I have sold one input shaft two left
Re: Input shafts
Posted: Sat Nov 23, 2024 8:04 pm
by ChickenPinz
Reviving an old thread -- any more of these out there?
I have the plastic tool, and mine is bent and I'd much rather have a metal version. An old transmission input shaft is the classic solution. Or is there an OTS [metal] tool that fits the Pinz clutch?