flasher connection-newbie needs help

Dedicated to the memory and knowledge shared by Jim Mettler - All things relating to the flow of electrons in a Pinz.
Post Reply
rdusek
United States of America
Posts: 10
Joined: Mon Sep 23, 2019 5:27 pm
Location: las vegas
Contact:

flasher connection-newbie needs help

Post by rdusek » Tue Dec 31, 2019 9:52 am

the flasher is gone from my truck and i'm installing a new one (NAPA EG-23 with 3 terminals) and i'm not sure which wires to connect to which terminals. I think the green wire goes on the X post (there are 2 green wires spliced together and I think it's ok to leave one free), the yellow/black wire on the L post, and the blue wire goes on the P post. I need to confirm all this before I install it and run power thru it. can anyone please tell me if this is correct? I appreciate the help and thank you.

User avatar
rmel
United States of America
Posts: 1148
Joined: Sun Sep 25, 2011 12:19 pm
Location: Woodside, CA
Contact:

Re: flasher connection-newbie needs help

Post by rmel » Tue Dec 31, 2019 10:31 am

X = 49 = Switched 24V = Green Wire
L = 49A = Load = Black/Yellow
P = C = Pilot indicator on the dash = Blue Wire
Puller: 71' 710K 2.7L EFI aka Mozo
Follower: Sankey MK 3, 3/4 Tonne
Rescue Pinz: 73' 712M

Driver: Ron // KO0Q

rdusek
United States of America
Posts: 10
Joined: Mon Sep 23, 2019 5:27 pm
Location: las vegas
Contact:

Re: flasher connection-newbie needs help

Post by rdusek » Tue Dec 31, 2019 12:47 pm

thank you very much for the reply, and so quickly. your expertise is very much appreciated.

Post Reply