Looking for the shaft securing tool

milesdzyn · Post by **milesdzyn** » Thu Mar 29, 2007 2:35 am

Anyone know who has the shaft securing tool in stock part#905.3.36.405.2

Or if anyone has a drawing so I can have a shop make one up for me.

Any home brewed ways of accomplishing the same thing as using the special tool.

Miles

Jim LaGuardia · Post by **Jim LaGuardia** » Thu Mar 29, 2007 1:24 pm

That tool is not neccessary, A large screwdriver will get better results

Been there done that(several times)

milesdzyn · Post by **milesdzyn** » Thu Mar 29, 2007 6:22 pm

Thanks Jim...I was thinking of two rods criss crossed from opposite sides secured from movement. And since I only have one set of screwdrivers would hate to end up needing the one I stuck in there to hold it.

Sent you a PM, Miles