Studs

Boelt63A · Post by **Boelt63A** » Sun Jun 03, 2007 7:58 pm

I want to get a die to run down my wheel studs to help get some of the burrs off.
Anyone know what the thread pitch is :?:

Chuck

Jim LaGuardia · Post by **Jim LaGuardia** » Sun Jun 03, 2007 8:56 pm

14x1.5

Boelt63A · Post by **Boelt63A** » Sun Jun 03, 2007 9:18 pm

Thanks Jim

Chuck

milesdzyn · Post by **milesdzyn** » Sun Jun 03, 2007 9:41 pm

Chuck... If its not to bad you may be able to use a thread repair file. Its like a file thats square and has diffrent thread pitches on each side. Mine is made by KD tools and has 2 sizes per side for a total of 8 thread sizes. Its a great tool for the occasional squished thread area. I use a standard chisel to rough the damaged area back to groves then follow up with the file. Works out well for on the trail as I like to make sure all sizes are covered with one tool. Another option is a miniture v shaped file that has the same angle as the tread grooves.

Miles