THE PORTAL HUB - Pinzgauers, Haflingers, Volvo 303s and more!

westernair wrote:now I need to cut the square hole for the 2 inch recever,

So are you going to have the receiver mounted to the body and not the drivetrain then? I would be a little unsure of doing that... having it attached to the rear "cone" off the rear differential is stronger I think.

Perhaps you are going for dual receivers?

The receiver is still anchored on the backbone. Basically I need to put a square hole through the bumper to allow for a 2 inch shaft to pass through the bumper and connect behind it. May just be a hitch extender installed.